Hayward Salt Cell No Power Light

Hayward websites have been developed in compliance with standards for internet explorer 10 or later.

Hayward salt cell no power light.

If the controller is still powered when unplugging the cell and then the cell is subsequently plugged back in it. My pool was installed in 2007 since then i have has 6 aqualogic boards and 2 cells installed. Remove the cell and clean per hayward s cleaning instructions pages 18 20. To luxurious salt water.

The 500 operation hour countdown timer expires. Electronic chlorinator cell test. I have had issues where th pump would turn on and off by its self. If the no cell power message remains replace the cell.

Reinstall the cell and check see note below. No cell power multiple times and low salt readings. Ie9 and older versions are not supported. To fix the problem manually reset the inspect cell led.

In this condition chlorine is still being produced. Check salt inspect cell led flashing or on the inspect cell led only flashes or stays on when. I am now in discussions with them again because low salt reading.